Items includedguide platecentring mandrelhinge location cutter HM Ø 35 mmdowel drill HW Ø 5 mm (V-shaped tip)dowel drill HM Ø 5 mm (with centring bit and pre-cutter)2 parallel side fences with adjustable stopFSZ 120 fastening clamps (two units)2x Longitudinal stopscrewdriver, WAF 5Systainer SYS 1 T-LOCHole series are always drilled with a spacing of 32 mm and a hole diameter of 5 mm or 3 mm. The hole series drilling system is a complete set for fast and simple production of series of holes for shelf supports, rear wall supports and fittings with the OF 1010 or OF 1400 router. Everything in a single Systainer.
for use with hole line guide railsMain applicationsComplete range for preparing holes series with 32 mm spacingIncluding dowel drill dia. 5 mm and clampsHole spacing 32.00 mmLength of series of holes (without guide extension) 1400 / 2424Side stop setting range 0 - 110 mmWeight 0.90 kg